Author: FENG Jiahao |
A recent study titled III-nitride-based in-sensor computing enabled by interfacial polarization effects has been published in Nature Materials. Researchers at the State Key Laboratory of Luminescence Science and Technology, Changchun Institute of Optics, Fine Mechanics and Physics of the Chinese Academy of Sciences led the work with collaborators from Peking University, East China Normal University, the Shanghai Institute of Technical Physics of the Chinese Academy of Sciences and Zhejiang University.
The team developed an aluminium gallium nitride device that combines light detection, memory and basic processing by controlling charge at polarization interfaces. Experiments showed sensitivity to light at the nanowatt-per-square-centimetre level and stable operation at temperatures up to 300 degrees Celsius.
In-sensor computing reduces the need to transfer raw data between separate detectors, memory units and processors. Existing devices often rely on defects to store charge, which can consume photogenerated carriers and weaken the response. Other approaches use stacked two-dimensional materials that remain difficult to manufacture over large areas. Group III nitride semiconductors offer a different route because their material quality, fabrication processes and industrial supply chain are already well established.
The new device uses an aluminium gallium nitride heterostructure with alternating layers of different composition. The change in composition creates interfaces with opposite polarization charges and built-in electric fields. These fields drive photogenerated electrons and holes toward different interfaces, reducing their recombination. Asymmetric nickel and titanium contacts then control how the separated carriers move. Under forward bias, holes are retained at one interface while electrons produce a readable current, allowing the incident light to be stored. Under zero or reverse bias, the stored holes are released and both carrier types move rapidly, switching the same component into a detector.
This control scheme gave the fabricated device several operating modes without changing its physical structure. It could record a persistent optical state after bright illumination, form multiple temporary states under weaker pulses and return to its initial condition through an electrical reset. In detector mode, it responded on the nanosecond timescale. The device also maintained a large current contrast and repeatable write and erase behaviour after extended storage in air.
To assess its computing potential, the researchers used experimentally measured device states in a neural-network simulation for clothing-image classification. The device-based model achieved more than 90 percent accuracy and remained close to the corresponding full-precision software model. Tests on a fabricated device array further showed that individual pixels could detect and retain optical inputs, supporting the use of the material platform for parallel sensing and local preprocessing.
The study also clarifies the current limits. It demonstrates individual devices and a small array rather than a complete large-scale computing system. The image-classification result was obtained through a network simulation parameterized by experimental measurements. System-level energy consumption, integration density, readout circuitry and manufacturing yield therefore still need direct evaluation in larger hardware implementations.
The results identify interfacial polarization as a practical design tool for integrating sensing and memory in a mature semiconductor family. Because the device uses one nitride material system and standard fabrication steps, the approach may simplify future integration with established semiconductor processes.
LI Dabing
Changchun Institute of Optics, Fine Mechanics and Physics
E-mail: lidb@ciomp.ac.cn